To View Documents: Select from the language listed per sheet

AD-01 Supplementary Cementitious Materials
AD-02 Cold Weather Concrete Practices
AD-03 Hot Weather Concrete Practices
AD-04 Set Retarding Admixtures
AD-05 Shrinkage Control Additives
AD-07 Offsetting Potential Corrosive Effects of Chlorides Using Eucon CIA
AD-08 What is PLC or Type IL?
CP-01 Chemical Grouts Hydrophobic vs Hydrophilic
CP-02 Chemical Resistance of Cured Eucolastic Sealants
CP-03 Coating Defects Caused by Concrete Outgassing
CP-04 Cold Temperature Installation of Joint Fillers
CP-05 Concrete Sealer Troubleshooting
CP-06 Eucolastic 1SL and Jet Fuel Resistance
CP-07 Eucolastic Sealants Paintability
CP-08 Eucolastic Sealants Maintenance Instructions
CP-09 Eucolastic Sealants ASTM C 920 Cold Weather Installation Recommendations
CP-10 Eucolastic Sealants ASTM C 920
CP-11 Exterior Use of Dry Shake Hardeners
CP-12 Installation of Eucolastic 1SL on Green Concrete
CP-13 Joint Filler Bubbling
CP-14 Joint Filler Elongation Separation and Repair
CP-15 Latex Bonding Agents
CP-16 Maintenance of a Diamond Hard Treated Floor
CP-17 Maintenance of Euclid Chemical Epoxy and Urethane Floor Coating System
CP-18 Sealants VS Joint Fillers
CP-19 Silane and Siloxane Water Repellents for Concrete and Masonry
CP-20 Silicates, Siliconates, and Fluorosilicates Explained
CP-21 Solvent Based Sealer Technical Tip
CP-22 Tire Marking Pickup of Concrete Sealers
CP-23 Using Epoxy Coatings in Cold Weather
CP-24 Water Based Sealers: Guide to Successful Application
CP-25 Duralprep A.C. Compressive Strength
CP-26 Epoxy vs Polyurea Joint Fillers
CP-27 Standard Floor Joint Filling Details
CP-28 Wet Mils Conversion Chart
CP-30 Efflorescence - Causes, Prevention, and Removal
CP-29 Epoxy Guide
FC-01 Difference Between Micro and Macro Fibers
FC-02 Tuf-Strand SF Slab on Ground Design for Temperature & Shrinkage Crack Control
FC-03 Thin Wall and Precast Design for Bending Moment Steel Conversion
FC-04 FAQs on Slump, Air Content and Compressive Strength when using TUF-STRAND SF
FC-05 FAQs on Steel Fibers vs. Synthetic Fibers
FC-06 FAQs on Fiber Types and Mixing Problems
FC-07 FAQs on Concrete Thickness and Finishing
FC-08 FAQs on Technical Issues when using Fibers
FC-09 FAQs on Secondary Reinforcement and Composite Steel Deck Systems
FC-10 FAQs on Pumping and Finishing Fiber Reinforced Concrete
FC-11 Performance-Based Specifications for Fiber Reinforced Concrete
FC-12 Recommended Practices for Addition of TUF-STRAND SF to Ready-Mixed Concrete
FC-13 FAQs on Floor Joint Spacing with Fibers
FC-14 Blended Fiber Systems for Concrete Reinforcement
FC-15 Engineering Design Tables for Nudura® ICF WALLS with TUF-STRAND SF™